Setting Programmable Controllers MELSEC - MELSEC iQ-R series
GX Works3 (Update version)
Language
Overview
This is an updated version of the sequencer engineering software GX Works3 Version1 (English version) SW1DND-GXW3-E.
[Supported series*]
MELSEC iQ-R series, MELSEC iQ-F series
*Please refer to the "GX Works3 Operating Manual" for details on supported CPU models, etc.
[Important Notice]
In GX Works3 Ver.1.100E, if you edit or convert lines of a ladder program circuit multiple times, inconsistencies may occur in the project when reading from the sequencer. . Therefore, please do not use projects read from the sequencer.
If you edited the ladder program using GX Works3 Ver.1.100E, please convert the entire project using Ver.1.101F or later.
If you edited and wrote the ladder program with Ver.1.100E, please convert the entire project before writing and write again with Ver.1.101F or later.
This issue does not occur if the following apply:
- You are using a project of GX Works3 Ver.1.097B or earlier.